Dsp Sine Wave Inverters

Product Code : 01

Product Specification

Dsp Sine Wave Inverters
DSP based sine wave inverters are true sine wave inverters, these are advanced technology solution to give clean power, long back up and increase battery life with in built battery saver. Its dynamic and intelligent five stage battery charger fast charges the battery, reduce electricity bill and adjust it self to battery conditions.

Features
VOLTAGE LIMITS (INVERTER MODE)

Mains A.C. Lower Voltage Limit :110+ 5V Lower Recovery Voltage :120+ 5V
Mains A.C. Higher Voltage Limit : 275+ 5V Higher Recovery Voltage : 265+ 5V
Output Voltage in Inverter Mode : 210V+5%

VOLTAGE LIMITS (UPS MODE)

Mains A.C. Lower Voltage Limit :180+ 5V Lower Recovery Voltage : 190+ 5V
Mains A.C. Higher Voltage Limit : 255+ 5V Higher Recovery Voltage : 245+ 5V

Output Frequency Main Output Frequency : Same as Input Inverter, Output Frequency : 50.0+0.3Hz

Battery Charging

Battery Charging Voltage Range :120 V to 280V
Bulk Charging Current :11.0+1.0Amp for High, 8-10 Amp for Low
Boost Charging Current : 6+2.0Amp
Float Charging Current :< 1 A
Trickle Charging : 3+0.3A (When Battery Is Fully Discharged)
Battery Charger Boost : 14.4+0.2V (Per Battery)
Battery Charger Bulk Voltage : 13.6+0.2V (Per Battery)
Provision for HI LOW charging
Battery Lower Voltage Limit :10+0.3(for 12V System)
THD : <1.5% on no load and <5. % on full load

PROTECTION
Overload :100+3 %( With Auto Reset Function) >300 %( With Manual Reset Function Short Circuit, Low Battery and Reverse Battery (With Manual Reset Function)

Indications
Low Battery, Battery Charging, Battery charged, Main On, Inverter On, Overload, low Cut (battery), Short Circuit, Fuse blown, Reverse battery

CHARGER
DSP controlled CC/CV Charger with Soft Start

TECHNOLOGY

Processor: DSP
Conversion: Full H bridge
Switching: 20 Khz Modulation
Charging: Dynamic five stage charger to decrease charging time and increase battery life

MODELS
600VA, 800VA 1400VA